Glock 19 Gen 3 Guide Rod Hardware & 18 lb Recoil Spring Kit

Glock 19 Gen 3 Guide Rod Hardware and 18 lb Recoil Spring Kit

This is a complete guide rod hardware kit for Glock 19 Gen 3 compatible builds, including an 18 lb captured guide rod recoil spring, a Glock 19 Gen 3 compatible two-piece guide rod assembly, a guide rod washer, and a hex socket guide rod retaining screw. The guide rod is finished in black oxide and is intended for replacement, repair, or custom Glock 19 Gen 3 builds.

Key Features

• Glock 19 Gen 3 compatible platform
• 18 lb captured guide rod recoil spring
• Glock 19 Gen 3 compatible two-piece guide rod assembly, black oxide finish
• Guide rod washer included
• Guide rod retaining screw included, hex socket drive
• Complete guide rod hardware kit for replacement, repair, or custom builds

Perfect For

• Glock 19 Gen 3 owners replacing worn or damaged guide rod hardware as a complete set
• Builders sourcing a complete guide rod kit for a custom Glock 19 Gen 3 build
• Shooters looking to run an 18 lb recoil spring in a Glock 19 Gen 3 platform

Guide Rod Assembly and Spring

The kit centers on a Glock 19 Gen 3 compatible two-piece guide rod assembly in black oxide, paired with an 18 lb captured recoil spring. The two-piece guide rod design is the standard configuration for this platform and the captured spring keeps the recoil spring retained on the guide rod as a single unit. The 18 lb spring weight sits above the standard Glock factory spring weight and is a common choice for shooters running heavier loads or looking to tune the recoil impulse of their Glock 19 Gen 3. The guide rod washer and hex socket retaining screw are included as part of the complete hardware set, covering all mounting hardware needed to complete the guide rod assembly in the frame.

Follow safe handling and manufacturer instructions. Ensure compliance with all applicable federal, state, and local laws.