Davidson Defense AR-15/M16 Carbine Mil-Spec Adjustable Buttstock; Made in the USA!

Not a bad stock for the price. Be advised that this is a mil spec collapsible stock requiring a mil-spec buffer tube. I have this attached to my Mil-Spec buffer tube and this stock exhibits a fair amount of play (rattle, wobble, etc.) Still, at this price, it makes for a good starter stock. Easy to install and remove, and comes with one Quick Detachable Sling Swivel with 3 locations with which to attach it. The one I have will eventually be replaced with a Magpul with friction lock to take out the extra play, but for now it is completely adequate for my needs. I did have to sand out somevery minor mold lines (flash) with some 400 grit wet and dry aluminum oxide sandpaper to make it look pretty.

For the price you can't beat it. It's better than a traditional m4 stock bit not quite the quality of a magpul. It's a little loose so I used a couple pieces of the loop side of velcro and stuck it inside the opening. Tightened right up and still slides great. Give it a try for your next budget build.

Bought a few of these to complete some budget lower builds. They are comparable to to lower end magpul stocks and have a bit of wobble. That is easily fixed though.

Bought this for a carbine build. It is a pretty nice looking stock though 3 ozs heavier at 9.5 ozs than a regular M4 stock 6.4 ozs It seems to function as advertised and is a good value for the money if weight isn't an issue.

Went right on