P80 Standard Frame Hardware Kit for G17/G22 – Includes Front Locking Block, Rear Rail Module & Two-Pin Set for Glock Compact Frames

P80 Standard Frame Hardware Kit - PF940 - G17 and G22 Compatible - Front Locking Block, Rear Rail Module, Two-Pin Set

The P80 Standard Frame Hardware Kit includes the core hardware components for Polymer80 PF940 frame builds compatible with Glock G17 and G22 slides. The kit contains a front locking block, a rear rail module with left and right sections, and a two-pin set. All components are hardened steel with a raw machined steel finish that may vary by batch.

Key Features

• Front locking block, rear rail module with left and right sections, and two-pin set
• Hardened steel construction throughout
• Raw machined steel finish, may vary by batch
• Compatible with Polymer80 PF940 frames
• Glock G17 and G22 slide compatibility
• Uses standard Polymer80 pin specifications
• Approximately 2.5 oz kit weight, varies by components

Perfect For

• PF940 frame builders sourcing replacement or completion hardware
• Gunsmiths working with Polymer80 PF940 platform builds
• Builders pairing with G17 or G22 pattern slides

Front Locking Block and Rail Module

The front locking block is a single-piece component with a hardened steel construction and raw machined steel finish. The rear rail module includes both left and right sections, providing the structural rail interface for the PF940 frame. Both sections share the same hardened steel material and finish as the front locking block.

Two-Pin Set and Frame Compatibility

The two-pin set uses standard Polymer80 pin specifications for PF940 platform builds. All three component types in this kit, the front locking block, rear rail sections, and frame pins, are specific to Polymer80 PF940 frames with G17 and G22 slide compatibility. The combined kit weight is approximately 2.5 oz and may vary slightly depending on components.

Follow safe handling and manufacturer instructions. Ensure compliance with all applicable federal, state, and local laws.