Lionheart Ported Barrel G17 Gen 1-3 Compatible 9MM Burnt Bronze RMR Complete Slide Kit

This is a complete slide assembly built for Glock 17 Gen 1-3 platforms. The Lionheart Burnt Bronze Cerakote finish gives it a distinctive look, while the ported barrel reduces felt recoil and muzzle rise. The 13 lb reduced recoil spring keeps cycling smooth, and the short sight assembly provides a clean sight picture. This slide kit pairs directly with any standard Glock 17 Gen 1-3 lower receiver.

Key Features

• Burnt Bronze Cerakote slide finish on 17-4 stainless steel
• Ported barrel with nitride finish for reduced recoil and muzzle rise
• 13 lb reduced recoil spring for smoother cycling
• Short sight assembly kit included
• RMR cut ready for optic mounting
• Glock 17 Gen 1-3 compatible

Perfect For

• Shooters upgrading from stock Glock 17 slides
• Custom build enthusiasts wanting distinctive aesthetics
• Those seeking reduced recoil management
• Optic-ready configurations on established platforms
• Concealed carry or duty setups prioritizing ergonomics

Ported Barrel Design

The ported barrel channels gases upward during firing, which directly reduces muzzle rise and felt recoil. This design makes follow-up shots faster and more controlled, especially during rapid fire strings. The nitride finish protects the barrel from corrosion while maintaining dimensional accuracy. Porting does increase noise slightly compared to a solid barrel, but the recoil reduction benefit is noticeable in practical shooting.

Burnt Bronze Aesthetic and Durability

Cerakote Burnt Bronze is a ceramic-based finish that resists wear, corrosion, and fingerprints better than standard blued or parkerized coatings. The finish is applied to 17-4 stainless steel, which provides excellent structural integrity and longevity. This combination makes the slide suitable for high-round-count shooting without finish degradation. The aesthetic appeal is secondary to the protective properties of the coating system.

RMR Optic Compatibility

The slide comes pre-cut for RMR mounting, eliminating the need for additional milling. This allows direct installation of Trijicon RMR red dot sights or compatible optics. The cut is machined to standard RMR specifications, ensuring proper fit and zero retention. Optic mounting hardware is not included with this kit.

Glock 17 Gen 1-3 Platform Fit

This complete slide assembly is engineered for Glock 17 Gen 1-3 lower receivers only. Gen 4 and Gen 5 platforms have different rail and connector geometry and are not compatible. Verify your lower receiver generation before purchase to ensure proper fitment.

Follow safe handling and manufacturer instructions. Ensure compliance with all applicable federal, state, and local laws. Lower receiver not included. Verify RMR optic compatibility before mounting.